1. Make sure your gateway is online.
2. Check that all of the sensors are on your profile and the serial numbers match.
3. Take note of the serial number (it is easiest to make note of the last 4 digits instead of the whole number)
4. Write down where you will be placing the sensors next to the serial numbers you have noted.
5. Activate the sensors. Find out what type of sensor you have in our Temperature Sensors article, along with model-specific instructions in our Resetting your Squizify temperature sensor article.
6. Check if the sensors have taken a read by looking at the time and date below the temperature of the sensor. (These may automatically start reading or take up to 5 minutes to receive the first read)
7. Now all sensors have read, place them into their designated units. Ensure you receive 2 reads from the sensor inside the units before mounting.
The sensor installation steps are the same for all Gateway models and Gateway connection types.