How to set up the WiFi Standard gateway
You can refer to the Gateway Setup Guide at the link below and follow the steps to connect your Gateway.
Click Here ➡️ Gateway Setup Guide
- Step 1: Power On the Gateway
Plug the Gateway into power using the USB cable and adapter.
A solid red light indicates the device is powered on and ready.
- Step 2: Enter Wi-Fi Setup Mode
Press and hold the button until all three lights — Red, Green, and Blue — appear together, then release.
The lights will flash, pause, and flash again. The Gateway is now in Wi-Fi setup mode.
- While these lights are flashing go to the WiFi settings on your device. (computer, phone or tablet)
Select the serial number of your gateway on the available networks (The serial number can be found on the front sticker of the gateway.)
- Step 4: Enter the Password
If prompted, enter the password:
gnd@1234 + addition of the last two/three digits of the serial number
Example:
Serial: GSW0000077 → Password: gnd@123414
Serial: GSWCL00789 → Password: gnd@123424
- A setup page should open for you that looks like the screenshot to the right.
If this page does not load, please open your internet browser and type 192.168.4.1 into the address bar to open the setup page manually.
- Tap Configure WiFi, select your network, enter the Wi-Fi password, and tap Save.
- Select your WiFi network from the list and enter your WiFi password. (There is a show password button to help you double check you have typed the password correctly!)
- Select Save!
Your gateway will restart so don't be alarmed! It needs to restart to connect to your WiFi network.
Wait until the Red, Green, and Blue lights stop flashing.
The Blue light will indicate when the Gateway is connecting to the network.
- Check if your gateway has connected to the WiFi network.
If your gateway is not connected when you check on your sensors page wait up to 5 minutes and check this again, if it is still not connected please repeat the steps above.
- Check your gateway is connected on the profile using the guide below:
How to check the gateway is connected to the platform.
- Now you know your gateway is connected, place it in a central location to all the sensors to ensure the best connection. We suggest you place this on a high shelf or mount high on a wall using double sided tape. Make sure the cord reaches the power point and that all sensors are connected and reading consistently before you mount it!
- Start installing the sensors!
If you are still having troubles connecting your gateway please contact support@squizify.com to help you.
Updated on: 21/01/2026
Thank you!